Supershieldz(3 Pack) Designed for Samsung Galaxy Tab S2 and Galaxy Tab S3 (9.7 inch) Screen Protector, High Definition Clear Shield (PET)

UGH - terrifically difficult to apply. I freely admit that I'm not the best at applying screen protectors, but this was a complete fail for me.The kit comes with three screen protectors, a lint cloth and a "squeegee" to get the bubbles out. The squeegee is a thin piece of cardboard that is rendered useless within a couple of minutes. It isn't stiff enough to actually push the MANY bubbles out and quickly becomes bent and floppy.The instructions say to start applying the screen protector at the "Home" button - which is the large button at the bottom of the screen. Problem is, the "tabs" that are used to peel the protective layer away from the adhesive side of the screen protector is at the "top" of the screen. So in order to start applying the screen protector you have to remove the entire protective sheet off the adhesive side which is an ENORMOUS mistake. That leaves what is essentially a sticky lint magnet exposed to the world.The screen protector itself is very nice - it is a good thickness of plastic and fits the device perfectly. There is a very minimal gap at the edges, which is essential in order to get the air bubbles out. If you position the protector right up against the edge of your device, the air bubbles just collect there and cannot escape. I can't attest to how sensitive the screen is after application of this protector, because I trashed all three of them trying to get them applied. I had a constant problem with debris getting stuck to the sticky side of the protector as I was trying to apply it and once that happens, there is a permanent defect in the protector. I found it impossible to get the debris off without damaging the protector itself. Additionally, there were multiple air bubbles that would not push out and dissipate.It's back to Armour Shield for me. More expensive, but infinitely more forgiving during the application process.

Utter garbage. I've repaired dozens of phones and installed more screen protectors than I can imagine. These screen protectors are impossible to install without bubbles and lint. I don't even think it'd be possible in a clean room. There is so much inherent static electricity than no matter what precautions you take as soon as you remove the #1 peel here side every speck of dust within 3 miles is instantly attracted to it and instantly clings to the back side (screen touching side). Thus making it nigh impossible to install cleanly.

The worst screen protector ever. We tried all three screens and they were super difficult to put on with about 20 to 30 bubbles. We are generally pretty good at putting screen protectors on so it's not user error.The protector is super thin, probably will only protect from a scratch. We even got a scratch through the thin sheet onto the screen protector by trying to apply it. Currently writing this review through many bubbles and a scratch in the middle of the screen.Going to order another one from the last brand I used.

I'm sure this screen protector works great I order the pack of 3 figuring it would last a lifetime of my tablet washed my hands watch the installation video clean the surface on the table where I was going to put it on meticulously removed any and all dust particles from the screen Preparatory to applying the new Shield. Then the problem starts. You pull off the first side of the screen protector it's sticky underneath and dust in the air in my home sticks to it and gets trapped between the plastic and my device. Any and all attempts to relift the plastic and remove the offending dust particle only results in additional dust particles being trapped until you give up and throw away the screen and try for the second one. Then I threw away the second screen after another futile attempt. On the third try I had maybe 6 tiny dust particles on the edges of the screen outside of the touch area and decided to live with it. Next time I'm going to buy the type that you can slide around and pull off, wet, and reapply.

I had a terrible time installing this shield, I followed the video instructions but I wasted two shield before getting the third one installed and it looked pretty good, hardly no air bubbles until a few days later a huge air bubble appeared on the top left corner, no matter how much tried to get rid of no go. I have installed a fair amount of phone shields in the past and what I found strange that this kit did not have a sticky tape dust remover, unless you are installing this product in a clean room specks of dust get on the screen.MJ.

Read the reviews thought people were just being ridiculous about trying to put them on.... But this screen protector is the worst....will not line up.. You finally get one side to line up and the other side is off... just seems like maybe the whole thing's not the right size.....bubbles won't go away...just frustrating.Don't seem like they would protect much of anything either.. super thin...

I was a little skeptical since the price was so cheap, but I'm so happy I ordered this. I needed a screen protector so I wouldn't constantly have to keep cleaning my screen and this is perfect. I don't know how much protection it actually will provide but I have a case with a flap on my tablet so I'm sure it will be okay. And you get 3 for the price of 1, even better! It fits the Samsung Galaxy Tab S2 (9.7 inch) perfectly! I didn't follow the directions, I simply cleaned my screen removed tab 1 and applied it. I had to lift it off 2 times to get it right but each time it went back on with minimal bubbles. I only have 1 small bubble near one of the corners but other than that it went on very easily.

Like most other people it took me three tries to get it on without bubbles. (I installed it in the bathroom with the window closed to minimize tiny dust particles.) At least I was put at ease from other reviews that this company will send you another pack of you mess up the first 3 shields. Once it was installed, the shield is completely invisible, and high quality so it doesn't feel plastic or rubbery to cause any drag which I experienced before with other screen protectors made for heavy-duty wear.

Difícil de colocar aún siguiendo las instrucciones al pie de la letra quedaron burbujas y es extremadamente delgado y suave, no protege mas que de rayaduras

los compre para una samsung galaxy tab s2 y no le quedaron

las tres micas que vienen función como intentos cuando no las sabes poner bien