LOWENERGIE7 Lath Pulley Clothes Airer Ceiling Maid Victorian Laundry Rack Dryer Maiden for Kitchen Utility or Garage (2.0 Meter, Black)

Easy to assemble and ideal for indoor drying without taking up room.

Been using this for a while now and it’s great.Usual gripes you see about sharp edges aren’t too bad - it is cast so I’d expect that but you won’t cut yourself.Wood is untreated but haven’t noticed it marking as of yet, and clothes come off unmarked and perfectly dry.The included fixings sheared clean off when I tried to mount the pulleys. I ended up grabbing some 6mm threaded rod from Screwfix and using that with large washers and double nuts to keep it secure but our beams are insanely oversized!The slats move around as there’s no way to affix them - just make sure when you mount it you leave at least 6 inches either side and that’s a non issue.For the money I can’t fault it. Just remember if you’re going to fully load it then it will be heavy.

Best thing I've bought in years. Easy to assemble and easy to use. Fantastic for drying your clothes up in air and out of the way. Definitely worth the money and will be used for years to come.

Looks fab in the picture but not the best quality wood moves when ever you try to put something on it

Very sturdy, needs to be anchored properly and it can be quite heavy to pull up when it loaded with clothes from the washing machine but overall i would recommend it.

If this was a cheap product, I could forgive the appalling quality of the metalwork. Sharp, rough edges everywhere. I drilled a pilot hole and screwed in one of the pulley wheels, only for the screw to snap. I'm a joiner with 20years experience, not a new DIYer. The quality is simply unacceptable.Also, in order to get a refund, the return postage cost me money 🤦🏻‍♂️Avoid

The only very small grow I have with this is that there is no fixing to stop the wooden slats starting in place. I've used cable ties but with upgrades to small screws at some point.This means you can easily adjust the length of the system which is great for making sure you can set it up regardless of the spacing of your joists.The only other tiny niggle is that the rules attach at the centre of the metal supports so you have to balance the washing!

The pulley wheels did not rotate smoothly, as they were held in by a normal bolt where the screw threads caused them to sometimes catch when spinned. I replaced the bolt with a solid rod and tapped the ends using a 2BA dia and fitted 2BA nuts. The pulleys now spin freely.